29R5905752 /16 DP2K C
3.1 Positioning the projector at the port window ....................................................................................30
3.2 Installation of the exhaust system ..................................................................................................32
3.3 Connecting the projector with the power net....................................................................................33
3.4 Power loop through to the projector electronics ...............................................................................35
3.5 Connecting a UPS with the projector electronics .............................................................................37
About this chapter
This chapter describes how the mechanical set up of the projector has to be done and how to realize the
electrical connections.
The light pipe is made out of magnesium. If used in high humidity conditions, there might be some
corrosion visible. However, this does not affect the performance of the projector.
Physical installation 3
To Next Page
Loading...
Need help?
General
