R5905752 /16 DP2K C70
6.1 Introduction
General
The Input & Communication side of the projector consists of a Local Keypad and a card cage with four slots.
The rear side of the projector is equipped with a tail light which reflects the status of the projector.
Depending on the projector configuration the projector card cage is equipped with an ICP(-D) or ICMP-X. See
illustration below. In case an ICP(-D) is installed then an IMB, IMS, or HDSDI input module can be optionally
inserted into the slot below the ICP (-D). Note that all information about the ICMP-X is gathered into one
separated chapter called ICMP.
Image 6–1
1 Fan Control Board (FCB).
2 Integrated Cinema Processor (ICP) or Integrated Cinema
Processor - Direct (ICP–D).
3 Optional slot for either IMB, IMS or HD-SDI input module.
4 Cinema Controller.
5 ICMP-X (inserted in ICP slot and optional slot).
CAUTION: A unit may only be removed from the card cage by qualified service personnel.
Removing one of the boards (except for the Cinema Controller) will result in an authorization
request upon starting.
6.2 Local keypad
Identification of the keys
Image 6–2 Local keypad
1 Marker area for macro name
2 Numeric keyboard
3 Standby key
4 Dowser open/close switch
Input & communication
To Next Page
Loading...
Need help?
General
