39R5905752 /16 DP2K C
4.1 Introduction ..................................................................................................................................40
4.2 Removal of the lamp house ...........................................................................................................41
4.3 Removal of the xenon lamp ...........................................................................................................42
4.4 Installation of the Xenon lamp........................................................................................................46
4.5 Installation of the lamp house ........................................................................................................51
4.6 Resetting the lamp parameters ......................................................................................................53
4.7 Realignment of the lamp in its reflector ...........................................................................................54
About this chapter
This chapter enumerates all the supported xenon lamps for the DP2K-xxC and how to replace the xenon lamp
in the lamp house. Also included is the procedure to reset the lamp parameters, which is required after a
xenon lamp replacement, and the procedure to realign the lamp in its reflector for optimal performance.
WARNING: DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY
PHASE OF XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED
TECHNICAL SERVICE PERSONNEL ARE ALLOWED TO HANDLE THE XENON LAMP.
CAUTION: Xenon compact arc lamps are highly pressurized. When ignited, the normal operating
temperature of the bulb increases the pressure to a level at which the bulb may explode if not
handled in strict accordance to the manufacturer's instructions. The bulb is stable at room
temperature, but may still explode if dropped or otherwise mishandled. Whenever the lamp house,
containing a xenon lamp, has to be dismantled or whenever the protective container or cloth has to
be removed from the xenon lamp, authorized protective clothing MUST be worn!
WARNING: Always wear face protection (full face shield) when handling xenon lamps.
WARNING: Always wear protective clothing (welder's jacket) when handling xenon lamps.
WARNING: Always wear clean leather gloves with wrist protectors when handling xenon lamps.
Lamp & Lamp
House
4
To Next Page
Loading...
Need help?
General
