125R5905752 /16 DP2K C
How to remove the input cover of the projector?
1. Release the two captive screws at the top and bottom left side of the input cover, using a flat screw driver.
Image 10–3 Release input cover
2. Remove the input cover from the projector doing the following:
1. gently pull out the right bottom corner (A) of the input cover,
2. then gently pull out the right top corner (B) of the input cover,
3. then move the input cover away from the projector (C).
Image 10–4 Remove input cover
10.3 Removal of the front cover
The input cover and the lens have to be removed before removing the front cover. See procedures
“Removal of the input cover”, page 124, and “Lens removal”, page 62.
Required tools
Flat screw driver
How to remove the front cover of the projector
1. Check if the input cover and the lens are removed.
2. Remove the rubber dust ring from the lens holder. See the detail at the right side of Image 10–5.
3. Release the captive screw at the middle bottom of the front cover, using a flat screw driver.
Removal and installation of projector covers
To Next Page
Loading...
Need help?
General
