Foreword
1.2 Documentation issue status
Issue Comment
1.2 Chapter update:
4.2; 4.5; 6.1.1; 6.1.2; 6.2.3; 6.4; 7.2; 7.5.1; 7.5.2
New and deleted chapter:
New: 4.4.1; 6.1.3
Deleted: 7.3
1.1 Chapter update:
3.2; 6.1; 6.1.1, 7.3
New chapter:
Technical data
1.0 First edition
1.3 Intended use
The linear eXtended Transport System (XTS) is designed for machines and equipment with the highest
demands on dynamics and positioning accuracy. All components of the eXtended Transport System (XTS)
are exclusively intended to be programmed and commissioned using the TwinCAT automation software
from Beckhoff Automation GmbH & Co. KG.
WARNING
Caution - Risk of injury!
Electronic equipment is not fail-safe. In case of failure of the drive system, the machine
manufacturer is responsible for ensuring that the connected components of the eXtended
Transport System (XTS) and the machine are brought into a safe state.
WARNING
Commissioning of the eXtended Transport System (XTS)
The eXtended Transport System (XTS) must be commissioned based on the requirements
of the currently valid EU Machinery Directive. Furthermore, the client must ensure that all
components installed in the system have a valid serial number.
All components of the eXtended Transport System (XTS) are installed exclusively in electrical systems or
machines. They may only be commissioned in connection with components of the eXtended Transport
System (XTS) and the previously designed plant. Furthermore, it is essential to take into account all
environmental conditions defined in this document before the eXtended Transport System (XTS) is
commissioned.
eXtended Transport System Start-Up6
Version: 1.2
To Next Page
Loading...
Need help?
General
