43
INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX
TRAFF. JAM
ROUTE OPTI
NAVI
NAV
T
MC
T
MC
B6, WESTSC
HNELLWEG
FM1 NDR 2
NAV
16mi10 16
pm
Dynamic navigation
During dynamic navigation, the TravelPilot analyses digital traffic information
messages and uses this information when planning the route. The system
receives the traffic messages from TMC (Traffic Message Channel) stations.
These are RDS stations that additionally broadcast their traffic messages in
digital form. If the system is already receiving a TMC station, the TMC symbol
will appear on the display.
If you want to make a currently active navigation session dynamic,
1 press and hold down the NAV button 1 for longer than 2 seconds during
the active navigation session.
✔ A selection menu appears in the display.
2 Mark and confirm the ROUTE OPTIions menu item.
✔ The menu for setting the route options appears.
3 Mark and confirm the DYNAMIC route option.
✔ If the route option is activated, a filled-in square appears next to it.
Note: If you select dynamic navigation you can additionally choose
between a quick, short or optimum route calculation.
4 Press and hold down the OK button ; for longer than 2 seconds and then
press the ESC button =, or press the ESC button = twice.
✔ The system calculates the route again and the navigation display appears.
Furthermore, the TMC symbol is displayed surrounded by a border.
Notes: If necessary, you will be asked to insert the navigation CD-
ROM if it is not already present in the CD drive. The system must be
tuned into a TMC station during navigation in order to provide dy-
namic navigation. The TMC symbol flashes if the system is not tuned
into a TMC station.
DYNAMIC
FAST
o
SHORT
o
OPTIMUM
ROU=E OP=ION
NAV
T
MC
2 BA TPAmsterd_gb 26.09.2005, 12:46 Uhr43
To Next Page
Loading...
Need help?
General
