90
INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX
Installation
The installation menu contains all the necessary items for testing the TravelPilot
and preparing it for operation.
Switching the speed signal on/off
The TravelPilot give you the option of navigating with or without a speed signal.
To change the setting, please proceed as follows:
1 Switch off the ignition and turn on the device using button 3.
2 Press and hold down the menu button @ for longer than 2 seconds.
✔ The installation menu is displayed.
3 Mark and confirm the SPEED menu item.
✔ The settings menu for the speed signal is displayed.
4 Mark and confirm the ON menu item for navigation with the speed signal or
the OFF menu item for navigation without the speed signal.
✔ The installation menu is displayed.
After changing the setting, you can continue with the installation test in Point 3.
Installation test
The installation test allows you to check whether the system is correctly receiv-
ing signals from the sensors.
Note: The test must be carried out with the ignition switched off.
1 Switch off the ignition and turn on the device using button 3.
Note: If necessary, enter the numerical code.
2 Press and hold down the MENU button @ for longer than 2 seconds.
ON
OFF
SPEED
NAV
T
MC
INST. TEST
AUTO CALIB
MAN. CALIB
SPEED
ins=all
NAV
T
MC
6 BA TPAmsterd_gb 26.09.2005, 12:49 Uhr90
To Next Page
Loading...
Need help?
General
