54
INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX
Storing stations
Storing stations manually
1 Select the memory bank (i.e. FM1, FM2, FMT) that you want or one of the
wavebands (MW or LW).
2 Tune into the station that you want.
3 Press and hold down one of the station buttons 1 - 6 > for longer than
2 seconds to assign the station to that button.
✔ The stored station name or frequency is then displayed alongside the corre-
sponding preset memory button.
Note: The station name may be displayed in an abbreviated form
depending on how long it is.
Storing stations automatically (Travelstore)
You can automatically store the six stations providing the best reception in the
region (only FM). The stations are stored in the FMT memory bank.
Note: Any stations that were previously stored in this memory bank
are deleted in the process.
1 Press and hold down the BAND button 4 for longer than 2 seconds.
✔ The storing procedure begins. T-STORE appears in the display. Each stored
station is played for approx. 3 seconds. After the process has completed, the
radio will play the station that is stored in memory location 1 of the FMT
memory bank.
Listening to stored stations
1 Select the memory bank or waveband.
2 Press the station button 1 - 6 > that corresponds to the station that you
want to listen to.
NDR2 ffn
NJOY Ante
RAD2 JUMP
FM= =-S=ORE
NAV
3 BA TPAmsterd_gb 26.09.2005, 12:47 Uhr54
To Next Page
Loading...
Need help?
General
