To Next Page

To Previous Page

Luna

G3 APAP / Luna

G3 CPAP User Manual

15 / 49

• Please change the Air Filter regularly and don't block it; Fire, open ignition source

and smoking prohibited. (Refer to 18.6 Replacing the Air Filter)

CAUTIONS!

• The air filter must be in place when the device is operating.

• Device must be unplugged when installing the air filter and filter cap.

12.3 Connecting to Power

(1) Insert the plug of the power adapter into the DC Inlet on the back of the device.

(2) Connect the power cord to the power adapter.

(3) Plug the other end of the power cord into the power outlet.

Power Adapter

Power Cord

DC Inlet

Fig. 12-3

Note: The length of the power cord and power adapter is 1.5 m and 1.8 m

respectively without the function of preventing electromagnetic interference.

WARNINGS!

• The device is powered on for use when the power cord and power adapter is

connected. The Knob turns the blower On / Off.

• Use of the device at an AC voltage beyond the stated range (see Section 6 “AC

Power Consumption”) may damage the device or cause device failure.

• Connect to appropriate power for proper operation of the device.

• Inspect the power cord often for any signs of damage. Replace a damaged cord

immediately.

IMPORTANT TIPS!

• After interruption and restoration of the power supply, the device will restore its

pre-interruption working status automatically.

• To remove AC power, disconnect the power cord from the power outlet.

BMC REACTHEALTH Luna G3 APAP User Manual

Questions and Answers: