BMC REACTHEALTH Luna G3 APAP User Manual

Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual
21 / 49
Fig. 13-2
13.7 Turning the Device Off
Take off the mask and headgear, press the Start / Stop Button , and the
device will stop delivering air. Disconnect the power cord from the power outlet to
power off the device.
CAUTION!
• Do not position the device where it is difficult to disconnect the power cord from
the power outlet to power off the device.
14. Heated Humidifier
The humidifier is available from your home care provider. The humidifier may reduce
nasal dryness and irritation by adding moisture (and heat if applicable) to the airflow.
14.1 Filling the Water Chamber
14.1.1 Removing the Water Chamber
Press down the water chamber, and then remove it, as shown in Fig. 14-1.
Fig. 14-1
WARNING!
• Turn the device off and allow the heating plate and water to cool for
approximately 15 minutes before remove the Water Chamber.
14.1.2 Filling Water
(1) Remove the water chamber, open the cap, as shown in Fig. 14-2, and fill the
water chamber with approximately 360 mL of water, as shown in Fig. 14-3. Make
sure that the water does not exceed the maximum water level line.

BMC REACTHEALTH Luna G3 APAP Specifications

General

Brand	BMC
Model	REACTHEALTH Luna G3 APAP
Category	Respiratory Product
Language	English