To Next Page

To Previous Page

Luna

G3 APAP / Luna

G3 CPAP User Manual

19 / 49

SD Card Slot

SD Card

Fig. 12-8

If the SD card is inserted correctly, a symbol indicating correct insertion will

appear in the Main Interface on the screen of the device.

If the SD card is inserted incorrectly, a symbol indicating incorrect insertion will

appear in the Main Interface on the screen of the device.

CAUTIONS!

• If the SD card is not inserted, there will not be a symbol appear in the Main

Interface on the screen of the device.

• To avoid data loss or any damage to the SD card, the SD card can only be

removed after the device stops delivering air.

12.7 Starting Treatment

Connect the device to a power outlet, press the Start/Stop , and the device

will start delivering air.

WARNINGS!

• Be sure to follow your physician’s instructions on adjusting the settings! To order any

accessories not included with this device, contact your home care provider.

• DO NOT connect any ancillary equipment to this device unless recommended by

REACT HEALTH or your physician. If you suffer from chest discomfort, shortness of

breath, stomach bloating, or severe headache when using the device, contact

your physician or qualified medical personnel immediately.

13. Routine Use

13.1 Connecting the Tubing

Connect the power cord, power adapter, and tubing properly according to the

instructions in the First Time Setup (Chapter 12). Connect the mask and headgear

according to the user manual for the mask.

CAUTION!

• Before each use, examine the tubing for any damage or debris. If necessary,

clean the tubing to remove the debris. Replace any damaged tubing. Make sure

that the mask does not leak.

BMC REACTHEALTH Luna G3 APAP User Manual

Questions and Answers: