Practical interior equipment
114
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
You can operate the device with a running
engine or a switched-on ignition.
If the device cannot be operated even
after repeated programming, check
whether the original hand-held transmitter uses
an alternating-code system. To establish this,
either consult the operating instructions for the
original hand-held transmitter or press the pro-
grammed memory button 1 on the integrated
universal remote control for longer. If the LED 2
on the integrated universal remote control
flashes rapidly for a short while and then
remains lit for approx. 2 seconds, the original
hand-held transmitter uses an alternating-code
system. If it uses an alternating-code system,
program the memory buttons 1 as described
under Alternating-code hand-held transmit-
ter.<
Alternating-code hand-held
transmitter
To program the integrated universal remote
control, consult the operating instructions for
the device to be operated. The instructions
should indicate what scope there is for synchro-
nisation.
When programming an alternating-code hand-
held transmitter, the following points should in
addition be noted:
Programming will be easier if another per-
son is available to assist you.<
1. Park your car within the range of the radio
remote control device.
2. Program the integrated universal remote
control as described above in Fixed-code
hand-held transmitter.
3. Establish the location of the button on the
receiver of the device to be operated, e.g.
on the drive.
4. Press the button on the receiver of the
device to be operated. Once step 4 has
been performed, step 5 must be completed
within approx. 30 seconds.
5. Press programmed memory button 1 on
the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
If you have any queries in this regard,
please contact BMW Service or a work-
shop that operates to BMW specifications and
has suitably trained personnel.<
Deleting stored programs
Press and hold down the left-hand and right-
hand memory button 1 for approx. 20 seconds,
until the LED 2 starts to flash rapidly.
All stored programs are deleted.
It is not possible to clear programs individually.
Roller sun blinds*
Roller sun blind for rear window
From radio readiness onwards, briefly press the
button on the driver's door to operate.
Online Edition for Part no. 01 41 0 013 197 - © 02/07 BMW AG
To Next Page
Loading...
Need help?
General
