Adjusting
44
Memorising
1. Switch on radio readiness or the ignition,
see page 55.
2. Select the desired seat position and, in the
case of the driver's seat, the outside mirror
and steering wheel position.
3. Press the
M
EMORY button:
The LED in the button comes on.
4. Press the desired memory button 1 or 2:
The LED goes out.
Calling up
Do not call up memory when driving, oth-
erwise there is risk of an accident due to
unexpected seat or steering wheel move-
ment.<
Convenience function
1. The driver's door is opened after unlocking
or radio readiness is switched on.
2. Briefly press memory button 1 or 2 as
desired.
The adjusting procedure is halted when you
press a seat adjustment switch or touch one of
the memory buttons.
Safety function
1. Driver's door is closed and ignition switched
either on or off.
2. Press memory button 1 or 2 as desired until
the adjusting procedure has been com-
pleted.
If the
M
EMORY button was pressed acciden-
tally:
Press the button again; the LED will go out.
Head restraints
Head restraints adjusted to the correct height
reduce the risk of injuries to the neck in the
event of an accident.
Adjust the head restraint in such a way
that its centre is at approximately ear
level; otherwise there is an increased risk of
injury should an accident occur. Only remove
the head restraints if no one will be sitting on the
seat in question. Install the head restraints
again before transporting any passengers on
the seats, otherwise the passenger's head will
be unprotected.<
Front: adjusting height
Mechanically
> Up: pull.
> Down: press the button, arrow 1, and press
the head restraint down.
Removing:
1. Pull up the head restraint as far as the limit
position.
2. Press the button, arrow 1, and remove the
head restraint completely.
Electrically*
1. Select head restraint, button 1.
2. Adjust height, arrow 2.
Removing:
1. Extend the head restraint out in full.
2. Pull the head restraint out entirely with an
abrupt jerk.
Online Edition for Part no. 01 41 0 013 197 - © 02/07 BMW AG