Insert the ABS sensor into its
bore and install screw 1.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Removing rear wheel
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
Installing rear-wheel stand
( 152).
Slip wooden chocks or similar
under the rear wheel to prevent
it from dropping out after the
quick-release axle has been
removed.
Remove axle nut 1 with
washer.
Slacken locknuts 3 on left and
right.
Slacken adjusting screws 2 on
left and right.
Remove adjusting plate 4 and
push the axle in as far as it will
go.
Remove quick-release axle 5
and remove adjusting plate 6.
Roll the rear wheel as far
forward as possible and
disengage chain 7 from the
sprocket.
9
147
z
Maintenance
To Next Page
Loading...
Need help?
General
