Engage the rear-wheel stand in
the rear wheel swinging arm
and apply even pressure to
push it down to the ground.
Lighting
Replacing bulbs for low-
beam and high-beam
headlight
The positions of the plug,
the spring wire retainer and
the bulb might not be as illus-
trated below.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove cover panel 1 to re-
place the bulb for the low-
beam headlight.
Remove cover panel 2 to re-
place the bulb for the high-
beam headlight.
Disconnect plug 3.
9
153
z
Maintenance
To Next Page
Need help?
General
