Switch on the DTC
function
Press and hold down button 1
until DTC warning light 2
changes status.
DTC warning light goes
out; if self-diagnosis has not
completed it starts flashing.
Release button 1 within two
seconds.
DTC warning light remains
off or continues to flash.
DTC function is switched on.
If the coding plug for the
SLICK riding mode is not
inserted, you have the
alternative of switching the
ignition off and then on again.
An DTC fault has occurred
if the DTC warning light
shows when the motorcycle ac-
celerates to a speed in excess
of 5 km/h after the ignition was
switched off and then on again.
Riding mode
Setting riding mode
Switch on the ignition.
Press button 1.
See the section entitled
"Engineering details"
for more information on the
various ride modes that can be
selected.
4
45
z
Operation
To Next Page
Loading...
Need help?
General
