10/60 Safety instructions
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
2.5 General safety instructions
• Observe applicable accident prevention and environmental protection regulations.
• Observe the safety regulations ofthecountry inwhich the product
isused/operated.
• Use Rexroth products only when they are ingood working order.
• Observe all notices onthe product.
• Do not install, operate, remove ormaintain Rexroth products ifunder the influence
ofalcohol, drugs ormedication that may affect your reaction time.
• Only use genuine Rexroth accessories and spare parts toensure there isno hazard
to persons from unsuitable spare parts.
• Observe the technical data and ambient conditions specified inthe product
documentation.
• Ifunsuitable products are installed orused inapplications that are ofrelevance
tosafety, unexpected operating conditions may occur inthe application, which
could result inpersonal injury orproperty damage. For this reason, only use
the product insafety-relevant applications ifthis use isexpressly indicated and
approved inthe product documentation, e.g.in explosion protection applications
orinsafety-related parts ofacontrol system (functional safety).
• Only commission the product ifit has been determined that the end product
(e.g.machinery orsystem) inwhich the Rexrothproducts are installed complies
with the country-specific provisions, safety regulations and standards for the
application.
• Use tools appropriate for the work being performed and wear appropriate
protective clothing toprevent punctures and cuts (e.g.when removing protective
covers, disassembly).
• There isarisk ofentanglement when operating the axial piston unit with abare
shaft end. Check whether ornot your machine requires additional safety measures
for your application. If necessary, make sure these are properly implemented.
• Depending onthe type ofcontrol used, electromagnetic effects can beproduced
when using solenoids. The energization ofelectromagnets with direct current (DC)
does not produce any electromagnetic interference (EMI), nor istheelectromagnet
influenced byEMI. Potential electromagnetic interference (EMI) exists
ifthesolenoid isenergized with amodulated direct current (e.g.PWMsignal).
The machine manufacturer should conduct appropriate tests and take appropriate
measures toensure that other components oroperators (e.g.with apacemaker)
are not affected bythis potentiality.