Bosch Rexroth A15VSO User Manual

26/60 Installation
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
7 Installation
Prior toinstallation, the following documents should betohand:
• Installation drawing for the axial piston unit (can beobtained from your contact
person atBoschRexroth)
• Hydraulic circuit diagram for the axial piston unit (in the installation drawing)
• Hydraulic circuit diagram for the machine/system (available from the machine/
system manufacturer)
• Order confirmation (contains the order-related technical data for your axial
pistonunit)
• Datasheet for the axial piston unit (contains the permissible technical data)
7.1 Unpacking
The axial piston unit comes inapolyethylene material (PE) corrosion protection film.
CAUTION! Danger due tofalling parts!
If the packaging isnot opened correctly, parts may fall out and damage the parts
oreven result ininjury.
▶ Place the packaging ona level surface with sufficient load-bearing capacity.
▶ Only open the packaging from the top.
▶ Remove the packaging from the axial piston unit.
▶ Check the axial piston unit for transport damage and completeness; seechapter4
"Scope ofdelivery" onpage17.
▶ Dispose ofthepackaging inaccordance with the regulations inyour country.
7.2 Installation conditions
The installation position and location oftheaxial piston unit essentially determine
how itisinstalled and commissioned (such aswhen filling and air bleeding the axial
piston unit).
▶ Install the axial piston unit sothat the expected forces and torque can
betransferred without any danger. The machine/system manufacturer
isresponsible for sizing the fasteners.
▶ Observe the permissible radial forces onthe drive shaft when driving with radial
loading (belt drives). If necessary, store the belt pulley separately.
▶ Make sure the axial piston unit isalways filled with hydraulic fluid during
commissioning and operation. Also do this also after relatively long standstill
periods, since the axial piston unit may drain out through the hydraulic lines.
▶ Direct the leakage inthe housing area tothe reservoir through the highest drain
port. Use aline size that matches the port.
▶ A check valve inthe drain line isonly permissible ona case-by-case
basis following consultation. Please consult your proper contact person
atBoschRexroth.
▶ To keep noise values low, use elastic elements toisolate all connecting lines from
all vibration-capable components (e.g.reservoir).
▶ Make sure the suction, drain, and return lines flow into the reservoir below the
minimum fluid level under all operating conditions. This will prevent air from
being drawn inand foam from forming.

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English