Bosch Rexroth A15VSO User Manual

36/60 Installation
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
3. For versions with through drive, install the auxiliary pump according tothe pump
manufacturer's instructions. The protective cover(5) isnot pressure-resistant and
should not beused during operation.
7.4.8 Hydraulically connecting the axial piston unit
NOTICE
Insufficient suction pressure!
Generally, aminimum permissible suction pressure atportS isspecified for axial
piston pumps inall installation positions. If the pressure atportS drops below the
specified values, damage may occur which may lead tothe axial piston pump being
damaged beyond repair!
▶ Make sure the necessary suction pressure ismaintained. This isinfluenced by:
– The piping (e.g.suction cross-section, pipe diameter, length ofsuction line)
– The position ofthereservoir
– The viscosity ofthehydraulic fluid
– A filter element orcheck valve inthe suction line (check the level
ofcontamination ofthefilter element regularly)
The machine/system manufacturer isresponsible fordimensioning ofthe lines.
Connect the axial piston unit tothe rest ofthehydraulic system inaccordance with
the hydraulic circuit diagram ofthemachine/system manufacturer.
The ports and fastening threads are designed for the maximum permissible
pressures p
max
, see Table 12 "Ports A15VSO/A15VLO series 11" onpage39. The
machine/system manufacturer isrequired toensure that the connecting elements
and lines correspond tothe specified application conditions (pressure, flow,
hydraulic fluid, temperature) with the necessary safety factors.
Connect only hydraulic lines that are match the axial piston unit port
(pressurelevel, size, system ofunits).
Observe the following information when routing the suction, pressure and
drainlines.
• Lines and hoses should beinstalled without pre-charge pressure sono further
mechanical forces are applied during operation that will reduce the service life
oftheaxial piston unit and, possibly, the entire machine/system.
• Use suitable seals assealing material.
• Suction line (pipe orhose)
– The suction line should beasshort and straight aspossible.
– Measure the line cross-section ofthesuction line sothepressure atthesuction
port does not drop below the minimum permissible pressure. Make sure the max.
suction pressure isnot exceeded (e.g.when prefilling).
– Make sure the connections and connecting elements are airtight.
– The hose must bepressure-resistant, also toexternal air pressure.
• Pressure line
– For the pressure lines, use only pipes, hoses and connecting elements rated for
the working pressure range specified indatasheet92801 (see Table 12).
Information on
routingoflines

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English