Bosch Rexroth A15VSO User Manual

50/60 Removal and replacement
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
11 Removal and replacement
11.1 Required tools
Removal can beperformed using standard tools. No special tools are necessary.
11.2 Preparing for removal
1. Decommission the entire system asdescribed inthe instruction manual for the
machine orsystem.
– Relieve pressure inthe hydraulic system according tothe instructions
ofthemachine orsystem manufacturer.
– Make sure the relevant system components are depressurized and de-energized.
2. Secure the entire system against being re-energized.
11.3 Performing the disassembly
Proceed asfollows toremove the axial piston unit:
1. Make sure you have the appropriate tools and wear personal protective
equipment.
2. Allow the axial piston unit tocool down until itcan beremoved without danger.
3. For below-reservoir installation, before removing the axial piston unit from the
entire system, seal the connection tothe reservoir ordrain the reservoir.
4. Place adrip tray under the axial piston unit tocollect any hydraulic fluid that may
leak.
5. Disconnect the lines and collect the escaping hydraulic fluid inthe drip tray.
6. Remove the axial piston unit. Use asuitable lifting device.
7. Completely drain the axial piston unit.
8. Plug all openings.
11.4 Preparing the components for storage orfurther use
▶ Proceed asdescribed inchapter6.2 "Storing the axial piston unit" onpage24.

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English