Bosch Rexroth A15VSO User Manual

14/60 General instructions onproperty damage and product damage
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
3 General instructions onproperty damage
and product damage
The following instructions apply tochapters 6 to14.
NOTICE
Danger from improper handling!
Product can bedamaged!
▶ Do not subject the product toimproper mechanical loads.
▶ Never use the product ashandle orstep.
▶ Do not put/place any objects onthe product.
▶ Do not strike the drive shaft oftheaxial piston unit.
▶ Do not set/place the axial piston unit onthe drive shaft orassembled parts.
▶ Do not strike assembled parts (e.g.sensors orvalves).
▶ Do not hit sealing surfaces (e.g.onthe work connections).
▶ Leave the protective covers onthe axial piston unit until you connect the lines.
▶ Disconnect all electrical connectors before arc welding orpainting.
▶ Ensure that the electronic components (e.g.sensors) are not electro-statically
charged (e.g.during painting operations).
Risk ofproperty damage due toinadequate lubrication!
Product can bedamaged ordestroyed!
▶ Never operate the axial piston unit with insufficient hydraulic fluid. Specifically,
make sure that the rotary group has sufficient lubrication.
▶ When commissioning amachine/system, make sure that the housing area and
the working lines oftheaxial piston unit are filled with hydraulic fluid and
remain filled during operation. Avoid air inclusions inthe forward drive shaft
bearing, especially with the axial piston unit installed with the drive shaft up.
▶ Check the hydraulic fluid level inthe housing area regularly and recommission,
ifnecessary. For above-reservoir installation, the housing area may drain out
through the drain line after prolonged standstill periods (air enters through the
shaft seal) orthrough the working line (gap leakage). This means the bearings
are insufficiently lubricated when the system isturned on.
▶ Make sure the suction line isalways filled with hydraulic fluid during
commissioning and operation.
▶ With above-reservoir installation, anaxial piston unit must bemoved tofull
swivel angle after nomore than three seconds during commissioning and
recommissioning. Make sure that the axial piston unit really does suck
inhydraulic fluid and build up pressure.
Mixing hydraulic fluids!
Product can bedamaged!
▶ Before installation, remove all fluids from the axial piston unit toprevent mixing
with the hydraulic fluid used inthe machine/system.
▶ Any mixture ofhydraulic fluids ofdifferent manufacturers and/or different types
ofthesame manufacturer isgenerally not permissible.

Bosch Rexroth A15VSO Specifications

General

Brand	Bosch
Model	Rexroth A15VSO
Category	Water Pump
Language	English