EasyManuals Logo
Home>Bosch>Water Pump>Rexroth A15VSO

Bosch Rexroth A15VSO User Manual

Bosch Rexroth A15VSO
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
40/60 Installation
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
Table 13: Tightening torques for female threads and threaded plugs
Ports
Maximum permissible
tightening torque offemale
threads M
Gmax
Required tightening torque
ofthreaded plugs M
V
WAF hexagon socket
ofthethreaded plug
Standard Thread size
ISO6149 M8×1 10Nm 7Nm 4mm
M10×1 30Nm 15Nm 5mm
M12×1.5 50Nm 25Nm 6mm
M14×1.5 80Nm 45Nm 6mm
M16×1.5 100Nm 55Nm 8mm
M18×1.5 140 Nm 70Nm 8mm
M20×1.5 170Nm 80Nm 10mm
M22×1.5 210Nm 100Nm 10mm
M27×2 330Nm 170Nm 12mm
M30×2 420Nm 215 Nm 17mm
M33×2 540Nm 310Nm 17mm
M42×2 720Nm 330Nm 22mm
M48×2 900Nm 420Nm 22mm
1)
The tightening torques for the threaded plugs are valid for the condition "dry" and "lightly oiled".
2)
The tightening torques for the threaded plugs are valid for the condition "dry" – inthe condition "lightly oiled", the tightening torques
for M10×1 are reduced to10Nm and for M12×1.5 to17Nm.
To connect the axial piston unit tothe hydraulic system:
1. Remove the protective plugs orthreaded plugs from the ports where the
connections should bemade according tothe hydraulic circuit diagram.
2. Make sure the sealing surfaces ofthehydraulic ports and functional surfaces are
not damaged.
3. Use only clean hydraulic lines orflush them before installation.
(Observechapter7.5 "Performing flushing cycle" onpage42 when you flush
out the entire system.)
4. Connect the lines inaccordance with the installation drawing and the machine
orsystem circuit diagram. Check that all ports are connected orplugged with
threaded plugs. With inside-reservoir installation, the housing oftheaxial
piston unit must befilled before fitting the lines and filling the reservoir with
hydraulicfluid.
5. Properly tighten the fittings (observe tightening torques!). Mark all properly
tightened fittings, e.g.with apermanent marker.
6. Check all pipes and hose lines and every combination ofconnecting pieces,
couplings orconnecting points with hoses orpipes toensure they are insafe
working condition.
Procedure

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch Rexroth A15VSO and is the answer not in the manual?

Bosch Rexroth A15VSO Specifications

General IconGeneral
BrandBosch
ModelRexroth A15VSO
CategoryWater Pump
LanguageEnglish

Related product manuals