Bosch Solution 2000 Quick Reference Guide

Programming Option Bits
Use option bits to program any combination of the four different options in one location by
adding the options together. Programming a zero disables all four options.
Example
If at Location 0178 you only want options 1, 2, and 4, add the numbers together and the total
is the number to be programmed. The number to be programmed is 7 (1 + 2 + 4 = 7).
Option Description
1 Arm/Disarm Reports only if alarmed
2 STAY Mode Arm/Disarm Reports Enable
4 Delay siren until transmission complete
8 Extend handshake wait time from 30 to 60 sec.
Table 2.2: Programming Option Bits
Installer's programming commands
Installer Programming Commands, displayed in below table can only be used when you enter
Installer’s Programming Mode. Enter the command followed by the [#] key.
Command Description
958 Exit from Installer’s Programming Mode without saving changes
959 Test IUI-SOL-ADAPTER
960 Exit from Installer’s Programming Mode with saving changes and system
reset
961 Reset the control panel to factory defaults
962 Copy the control panel memory to IUI-SOL-ADAPTER
963 Copy IUI-SOL-ADAPTER data to the control panel memory
965 Set up domestic dialing format
966 Enable/disable the automatic stepping of locations during programming
999 Display the control panel firmware version number
Table 2.3: Installer’s Programming Commands
2.3
2.4
Control Panel Programming | en 11
Bosch Security Systems, Inc. Quick Reference Guide 2015.06 | 03 | F.01U.298.027

Bosch Solution 2000 Specifications

General

Brand	Bosch
Model	Solution 2000
Category	Control Panel
Language	English