Programming
The programming options of the system are stored in a non-volatile EPROM. This memory
holds all information during a total power loss and can be changed as many times as required.
The entire programming sequence consists of entering a location number and changing the
data as required.
Use the following methods to program the system:
– Codepad
– A-Link Plus Software
TEXT LCD Codepad Menu Programming
1. Enable Text codepad and confirm that the system is in disarmed status.
2. To enter Installer’s Programming Menu, enter the installer code (Default = 1234) followed
by the [#] key or [-] key.
3. Programming: Select the menu and operate according to the menu prompt.
– Down to the next menu: Press [▼]
– Up to the previous menu: Press [▲]
– Enter menu or confirm input : [#]
– Back to the menu or exit programming item setting: Press [-]; or press and hold [-]
for 3 seconds to exit programming without saving changes.
– Operate according to the menu prompt. Select menu and enter or select data for
specific programming items to complete programming, step by step. For specific
items and options, refer to Programming Parameters, page 20.
4. After completing input, press [-] to get back to the previous menu. Complete all
programming input by repeating step 3 and press [-] to get back to the current main
menu level by level.
5. To use the TEXT LCD codepad in location programming mode (like IUI-SOL-ICON ), enter
programming option [8] [1].
– In location programming mode enter the programming location then [#].
– Enter the new data then [*] to save it. Enter [#] to go to the next location.
6. When [Confirm to Save Parameter Changes?] display, press [#] to save parameter
changes , exit menu programming and reset system.
2
2.1
Control Panel Programming | en 7
Bosch Security Systems, Inc. Quick Reference Guide 2015.06 | 03 | F.01U.298.027
To Next Page
Loading...
Need help?
General
