Bosch Solution 2000 Quick Reference Guide

Notice!
Below commands examples are operated via IUI-SOL-ICON codepad.
Add/Delete RF Device (Wireless Zones)
Notice!
The Solution 2000 control panel does not support wireless devices.
Add RF Device
Set RF receiver as RADION Receiver.
1. Enter the Installer Code, followed by [0] and the [#] key (for example, [12340#]).
2. Enter the Device Number (1 to 16) you want to add, followed by the [#] key.
3. Use manual mode or auto-learn mode to configure device RFID.
– In manual mode, enter the 9-digit RF device ID number, followed by the [#] key.
– Or press [*] key to switch into auto-learn mode. When icon numbers (1 to 16) flash,
trigger the RF device. The panel learns the RF device ID number and the last digit of
RFID number displays on the codepad. Press [#] key to confirm.
4. Enter [#] key to accept the default value for the RF zone input option. Or enter a different
zone input option (0 to 15), followed by the [#] key.
RF zone/device ID numbers and RF zone input option, refer to Zone/Device RFID and RF Zone
Option, page 45.
Delete RF Device
1. Enter the Installer Code, followed by [0] and the [#] key.
2. Enter the Device Number (1 to 16) you want to delete, followed by the [#] key.
3. Press the [*] key to delete the RF device.
Add/Delete RF Repeater
Notice!
The Solution 2000 control panel does not support RF repeaters.
Add RF Repeater
Set RF receiver as RADION Receiver.
1. Enter the Installer Code, followed by [0] and the [#] key (for example, [12340#]).
2. Enter the point ID of RADION Repeater (822 to 829) you want to add (822 = 1,823 = 2,
etc.), followed by the [#] key. Repeater number (1 to 8 ) displays on the ICON codepad.
3. Use manual mode or auto-learn mode to configure Repeater RFID.
– In manual mode, enter the 9-digit RF Repeater ID number, followed by the [#] key.
– Or press [*] key to switch into auto-learn mode. When icon numbers (1 to 16) flash,
tamper the RF Repeater. The panel learns the RF Repeater ID number and the last
digit of RFID number displays on the codepad. Press [#] key to confirm.
4. Enter [#] key to confirm the operation, or enter [*] to cancel.
Delete RF Repeater
1. Enter the Installer Code, followed by [0] and the [#] key.
2. Enter the point id of RADION Repeater (822 to 829) you want to delete, followed by the
[#] key.
3.1
3.2
14 en | Operating Commands Control Panel
2015.06 | 03 | F.01U.298.027 Quick Reference Guide Bosch Security Systems, Inc.

Bosch Solution 2000 Specifications

General

Brand	Bosch
Model	Solution 2000
Category	Control Panel
Language	English