Operating Commands
The system supports programmable 1- 4- digit Installer code or User Code to execute the
following operating commands.
No identical User Codes are allowed. User Codes are not permitted to be the same as Installer
codes.
For [Code] + [Number] commands, the code must be 4-digit.
Master/User
Command
Function Description Access Installer
Command
Function Description Access
Code+[0][#] Arm/Disarm both areas
at the same time
(U) Code+[0][#] Add or Delete RF
Devices
(I)
Code+[1][#] Change or Delete User
Code and RF Keyfob
(U) Code+[0][#] Add or Delete RF
Repeaters / Keyfobs
(ICON codepad only)
(I)
Code+[2][#] Change Domestic Phone
Number
(U) Code+[1][#] Set Days until the First
Test Report
(I)
Code+[3][#] Change Telco Arm/
Disarm Sequence
(U) Code+[2][#] Change Domestic
Phone Number
(I)
Code+[4][#] Setting STAY Mode 2
Zones
(U) Code+[3][#] Change Telco Arm/
Disarm Sequence
(I)
Code+[5][#] Turn Output On/Off (U) Code+[4][#] Setting STAY Mode 2
Zones
(I)
Code+[6][#] Setting the Date and
Time
(U) Code+[6][#] Enable Report Monitor
Mode
(I)
Code+[7][#] Walk Test Mode (U) Code+[7][#] Walk Test Mode (I)
Code+[8][#] Event Memory Recall
Mode
(U) Code+[8][#] Event Memory Recall
Mode
(I)
Code+[9][#] Duress Disarm (U) Code+[#] Enter Programming
Menu
(I)
Code+[*] STAY 1 Arm / Disarm
Or STAY 2 Disarm
(U) Code+[-] Enter Programming
Menu
(I)
Code+[#] AWAY Arm / Disarm (U)
Code+[0][1]
[*]
STAY1 Arm/Disarm Area
1
Or STAY2 Disarm Area 1
(U)
Code+[0][2]
[*]
STAY1 Arm/Disarm Area
2
Or STAY2 Disarm Area 2
(U)
Code+[0][1]
[#]
AWAY Arm/Disarm Area
1
(U)
3
12 en | Operating Commands Control Panel
2015.06 | 03 | F.01U.298.027 Quick Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
Need help?
General
