_____________________________________________________________________________________________________
Maintenance and Adjustments 57
LCD Display Alarm Description
CUTTER FAULT
The cutter operation failed
Possible causes:
• Cutter not installed
• Jam in cutter
• Defective cutter hardware, call for service.
Warning:
Turn OFF the Printer and remove the AC power
cord before attempting to remove any jam or
obstruction from the cutter.
RIB SAVER FAULT
The Ribbon Saver operation failed
Possible causes:
• Obstruction in ribbon area
• Ribbon Saver Option is not installed
• Defective ribbon saver hardware, call for
service.
CUTTER NotEQP
The Cutter Option is enabled and the cutter is not
present
RIBSVR NotEQP
The Ribbon Saver Option is enabled and the
ribbon saver is not present
5.3 Mechanical Adjustments
The following mechanical adjustments should be performed only when
required, additional sections that follow provide detailed descriptions for each
adjustment.
•• Media Width adjustment, (see Section 5.3.1).
•• Media sensor adjustment, (see Section 5.3.2).
•• Printhead Replacement, (see Section 5.3.3).
To Next Page
Loading...
Need help?
General
