6-2
Using the Fax Functions
Basic Procedures for Sending Faxes
This section describes the basic procedure for sending a fax.
1
Place your fax.
“Placing Documents” (→P.2-4)
“Supported Document Types” (→P.2-2)
2
Press [ ].
4
Specify the destination.
These are the following methods to specify a destination.
(For details, see P.6-4 to 6-5.)
Entering the fax number
Favorites list
Coded dial codes
Group dialing
Address book
- Sequential broadcast
(→P.6-11)
5
Press [ ] (B & W).
When your fax is placed in the feeder
The scan starts. Your fax is sent to the destination when the scan is
complete.
When your fax is placed on the platen glass
Perform the following procedure.
(1) Select the size of the original document using [ ] or [ ] and
press [OK].
Scan Size
LTR
LGL
STMT
(2) Place the next page on the platen glass and press [ ] (B & W).
Press [ ] (B & W) for each page.
(3) When all documents are scanned completely, select <Start
Sending> using [ ] or [ ] and press [OK].
Your fax is sent to your fax destination.
3
Specify the scanning settings as needed.
There are the three items you can specify.
(For details, see P.6-3.)
Resolution Settings
Density Settings
Sharpness Settings
The settings specified here are effective only for the
current sending operation. To make the settings
effective for all the fax operations, see “Changing the
Default Fax Settings” (→P.6-22).
To Next Page
Loading...
Need help?
General
