106
q: Wireless Multiple-Flash Photography with Manual Output
4
Select a firing group.
Press function button 3 <F>.
Turn <9> to select the group to set
the flash output to.
5
Set the flash output.
Press function button 3 <1>.
Turn <9> to set the flash output,
then press <8>.
When setting <f> <g> or
<f> <g> <h>, repeat
steps 4 and 5 to set the flash output
of all firing groups.
6
Take the picture.
X Each group fires at the set flash ratio.
When <t> is set, you can use any of A, B, or C as the firing group.
To fire multiple slave units with the same flash output, select <t> in
step 3.
To Next Page
Loading...
Need help?
General
