69
a: Fully Automatic Wireless Flash Photography
4
Position the camera and the
flash.
Position them within the range shown
on page 58.
5
Set the flash mode to <a>.
Press the <E> button on the
master unit.
Turn <9> to select <Q>, then
press <8>.
The slave unit is set automatically to
<a> during shooting, controlled
by the master unit.
Check that the firing group control is
set to <t>.
6
Check the transmission status
and charge status.
Check that the <D> lamp is lit in
green.
When the slave flash is ready, the AF-
assist beam emitter blinks at approx.
1-second intervals.
When C.Fn-20-1 is set on the master
unit (p.116), the master unit’s beep will
sound when recharging of all flash
units is completed.
Check that the <Q> icon is lit on the
master/slave unit’s LCD panel
(<G> is not displayed).
For the master unit’s LCD panel
illumination, see page 71.
Check that the master unit’s flash-
ready lamp is lit.
Slave flash ready
To Next Page
Loading...
Need help?
General
