105
This section describes wireless (multiple-flash) photography using
manual flash. You can shoot with a different flash output setting for each
slave unit (firing group).
1
Set the flash mode to <q>.
Press the <E> button on the
master unit.
Turn <9> to select <R>, then
press <8>.
The slave unit is set automatically to
<q> during shooting, controlled by
the master unit.
2
Set the firing group of the slave
units.
Operate and set the slave units one by
one.
Set to the group to be fired in step 3.
Press function button 4 to display
<M>
.
Press function button 3 <F>,
then select <f>, <g>, or
<h>.
3
Set firing group control.
Press function button 4 on the master
unit to display <M>.
Press function button 2 <T> to
set the group to be fired.
Each time you press the button, the
setting switches in the following
sequence: <t> 9 <f>
<g> 9 <f> <g>
<h>.
q:
Wireless Multiple-Flash Photography with Manual Output
To Next Page
Loading...
Need help?
General
