30
The FE (Flash Exposure) lock locks the correct flash exposure setting
for any part of the subject.
With <a> displayed on the LCD panel, press the camera’s
<
B> button. For cameras without a <B> button, press the <A>
(AE lock) or <7> button.
1
Focus on the subject.
2
Press the <B > button (8).
With the subject at the center of the
viewfinder, press the camera’s
<B> button.
X The Speedlite will fire a preflash and
the required flash output for the
subject is retained in memory.
X “FEL” will be displayed in the
viewfinder for approx. 0.5 sec.
Each time you press the <B>
button, a preflash will be fired and the
new flash output required at that time
is retained in memory.
7: FE LockN
If a correct exposure cannot be obtained when FE lock is performed,
<Q> blinks in the viewfinder. Move closer to the subject or open the
aperture, and perform FE lock again. You can also set a higher ISO
speed and perform FE lock again when using a digital camera.
If the target subject is too small in the viewfinder, FE lock may not be
effective.
To Next Page
Loading...
Need help?
General
