38
Flash coverage (the range covered by the flash light) can be set
automatically or manually. With the <L> (automatic) setting, the flash
coverage is adjusted automatically according to the focal length
(shooting angle of view) of the lens in use and the image sensor size
(p.26). With the <d> (manual) setting, you can manually set flash
coverage in the range of 20 to 200 mm.
1
Press the <[> button.
Press function button 1 <[>.
X The flash coverage value is
highlighted.
2
Set the flash coverage.
When you want to set the flash
coverage automatically, select <L>.
When using the manual setting for
the flash coverage, select <d> and
the value (indicating the focal length
in mm).
Turn <9> to set the flash coverage,
then press <8>.
e: Setting the Flash CoverageN
When you set the flash coverage manually, set the same or a wider
coverage than the angle of view for shooting to avoid darkening the
periphery of the picture.
When a lens with a focal length less than 20 mm is attached, the
<O> warning is displayed on the LCD panel. When using a camera
with the image sensor size smaller than full-frame, the <O>
warning is displayed when the actual shooting angle of view is wider than
the angle of view of a 20 mm lens.
When shooting with the camera and Speedlite’s PC terminal connected
by a commercially-available sync cord, set the flash coverage manually.
To Next Page
Loading...
Need help?
General
