INCORRECT FOCUS
When the Back Focus becomes out of focus due to some kind of shock, the following adjustments should be made with
the use of 200mm T-Type Collimator:
First, loosen only three of the S3787x4 Screws holding Focusing Ring C4256, determine the proper position by turning
C4256, and when the proper position is found, loosen the remaining one S3787 Screw.
Lastly, set the oo of C4256 to the camera's Range-Viewfinder Distance Scale and again tighten all four S3787x4 Sc-
rews.
See Repair Manual p. 6
When the double-image of the Range-Viewfinder does not align due to some kind of shock, adjustments should be made
after referring to the paragraph on "When the Range-Viewfinder's Double-Image does not align?
* * *
10
To Next Page
Loading...
Need help?
General
