2-2 Rusted release lever
Replacement
Refer to the item of release lever adjustment.
3 Inferior Release Ring 3-1 Rough surface of release pin
Polish using oil stone and after that put a little
liquid molybdenum.
3-2 Rough surface where touches to the helicoid
The disposal is same as mentioned in 3-1.
3-3 Bent release ring
Rectifying or replacement
IT CANNOT BE CHARGED.
1 Coming off Main Cocking 1-1 Loosened screw
Lever _ , , , , . ,
Refer to the item of main cocking lever
adjustment.
1-2 So much room space in the tension lever long
hole
the same as the above
2 Inferior Piston Move 2-1 The piston does not move.
Refer to the item of main cocking lever
adjustment.
2-2 Coming off piston spring
Hang it up and check the effect of spring.
3 Inferior Release Lever 3-1 Bent release lever
Move
After adjustment, check the gearing of release
and main cocking lever.
Refer to the item of main cocking lever adjust-
ment.
3-2 Inferior release spring
Replace it and refer to the item of release,
lever adjustment.
3-3 Rusted release lever
Replace and the rest is same as the above.
19
To Next Page
Loading...
Need help?
General
