DC10 E, DC20 E
SERVICE MODE / ADJUSTMENT
43
5-8-7 Release of Forced CVF ON
Procedure)
(1) Referring to the table shown below, make the setting.
Note) The monochrome image display mode can be reset by turning power off/on.
CS Function MD ADDR DT
Release of Forced 1) Make the setting shown at right
0 00 ST 0004 00 Start of setting
CVF ON 2) Perform storing.
↑↑
RD
↑ ↑
Completion of setting
(press the PAUSE button.)
STEP PROCEDURE
MONITOR
Microcomputer operation
To Next Page
Loading...
Need help?
General
