Firmware update
You can update the firmware of the printer, check the firmware version, or perform settings of a notification
screen, a DNS server and a proxy server.
Important
• The administrator password is required to change the settings if it is enabled to change the settings on
the operation panel using the administrator password.
• When you use this function, make sure the printer is connected to the Internet.
Note
• Check current version and Update notification settings are available when Disable is selected for
Enable/disable Wi-Fi of Wi-Fi in LAN settings.
• Install update
Performs the firmware update of the printer. If you select Yes, the firmware update starts. Follow the on-
screen instructions to perform update.
Note
• If the firmware update is not complete, check the following and take an appropriate action.
Check the network settings.
If Cannot connect to the server. is displayed on the touch screen, select OK and try again
after a while.
• Check current version
You can check the current firmware version.
• Update notification settings
When ON is selected and the firmware update is available, the screen to inform you of the firmware
update is displayed on the touch screen.
• DNS server setup
Performs settings for a DNS server. Select Auto setup or Manual setup. If you select Manual setup,
follow the display on the touch screen to perform settings.
• Proxy server setup
Performs settings for a proxy server. Follow the display on the touch screen to perform settings.
200
To Next Page
Loading...
Need help?
General
