Canon LV 7365 User Manual

2
3. Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
❶
Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and a POWER button.
• When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed to the off (

) po-
sition. Failure to do so may cause damage to the projector.
WARNING
LAMP
1. Toturnonthemainpowertotheprojector,pressthe
MainPowerswitchtotheonposition(I).
• The POWER indicator will light orange.
See the Power Indicator section on page 61 for more
details.
3.PressthePOWERbuttonontheprojectorcabinetor
thePOWERbuttonontheremotecontrolforabout1
second.
The POWER indicator will turn to green and the projec
-
tor will become ready to use.
After you turn on your projector, ensure that the com-
puter or video source is turned on and that your lens
cap is removed.
NOTE: If you turn on the projector immediately after the lamp is
turned off or when the temperature is high, the fans runs without
displaying an image for some time and then the projector will dis-
play the image.
MENU
BACK
KEYSTONE
WARNING
P
O
W
E
R
AUTO PC
INPUT
VOL
-
VOL
+
LAMP
POWER
INPUTIMAGE
ASPECT
INFO.
MENU
NO SHO W
AUTO PC
WARNING
LAMP
WARNING
LAMP
WARNING
LAMP
Standby Blinking Power On
S t e a d y or-
ange light
Blinking
green light
Steady
green light
See page 61 for more details.
2.Removethelenscap.
CAUTION:
The projector cannot be turned off for 60 seconds after
the lamp is turned on and while the POWER indica-
tor is blinking green. Doing so could cause premature
lamp failure.
M
E
N
U
B
A
C
K
K
E
Y
S
T
O
N
E
W
A
R
N
I
N
G
P
O
W
E
R
A
U
T
O
P
C
I
N
P
U
T
L
A
M
P
V
O
L
-
V
O
L
+

Canon LV 7365 Specifications

General

Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	300 \
Projector native resolution	XGA (1024x768)
Focus	Manual
Digital zoom	4 x
Focal length range	17.7 - 28.3 mm
Aspect ratio	4:3
Dimensions (WxDxH)	310 x 265 x 109 mm
Power requirements	100V - 240V AC, 50/60Hz
Lamp type	NSH
Lamp power	210 W
Light source type	Lamp
Dot clock scanning frequency	108 MHz
RMS rated power	5 W
Headphone outputs	1
Power consumption (standby)	9 W
Power consumption (typical)	295 W

Weight and Dimensions

Weight	3300 g