Canon LV 7365 User Manual

55
5. Using On-Screen Menu
[Version]
[Model] [Firmware version]
[Serial number] [Data version]
❽
Menu Descriptions & Functions [Reset]
Resetting settings and adjustments [Reset]
The Reset feature allows you to change adjustments and settings to the factory preset for a (all) source (s) except
the following:
[Current signal]
Resets the adjustments for the current signal to the factory preset levels.
The items that can be reset are: [Image mode], [Brightness], [Contrast], [Sharpness], [Color level], [Color bal-
ance], [Aspect], [Horizontal position], [Vertical position], [Clock], [Tracking] and [Video lter].
[All data]
Reset all the adjustments and settings for all the signals to the factory preset.
All items can be reset except [Language], [Communication speed], [Password], [Filter message]*¹, [Fan mode]*²,
[Remaining lamp time], [Lamp counter] and [Filter counter].
*¹: The Filter message item can be selected on LV-7365 only.
*²: The Fan mode settings will not be reset only on LV-7365.
Clearing Lamp Hour Meter [Lamp counter]
Resets the lamp clock back to zero. Selecting this option displays submenu for a conrmation. Select [Yes] and
press the OK button.
NOTE:Elapsed time of the lamp use will not be affected even when [Reset] is done from the menu.
NOTE: The projector will turn off and go into standby mode after 2100* hours (up to 3100* hours in Quiet mode) of service. If
this happens, press the INFO button on the remote control for ten seconds to reset the lamp clock back to zero. Do this only
after replacing the lamp. * LV-X7: 3100 hours (up to 4100 hours in Quiet mode).
NOTE: Resetting the lamp counter before or without replacing the lamp will not display the exact lamp usage hours. Using the
lamp beyond its service life may cause the lamp to break. Be sure to reset the lamp counter after replacing the lamp.
Clearing the Filter Usage Hours [Filter counter]
Resets the lter usage back to zero. Selecting this option displays submenu for a conrmation. Select [Yes] and
press the OK button.
NOTE: Elapsed time of the filter use will not be affected even when [Reset] is done from the menu.

Canon LV 7365 Specifications

General

Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	300 \
Projector native resolution	XGA (1024x768)
Focus	Manual
Digital zoom	4 x
Focal length range	17.7 - 28.3 mm
Aspect ratio	4:3
Dimensions (WxDxH)	310 x 265 x 109 mm
Power requirements	100V - 240V AC, 50/60Hz
Lamp type	NSH
Lamp power	210 W
Light source type	Lamp
Dot clock scanning frequency	108 MHz
RMS rated power	5 W
Headphone outputs	1
Power consumption (standby)	9 W
Power consumption (typical)	295 W

Weight and Dimensions

Weight	3300 g