Canon LV 7365 User Manual

56
6. Maintenance
M
E
N
U
B
A
C
K
K
E
Y
S
T
O
N
E
W
A
R
N
I
N
G
P
O
W
E
R
A
U
T
O
P
C
IN
P
U
T
L
A
M
P
-
+
V
O
L
V
O
L
This section describes the simple maintenance procedures you should follow to clean the lter and replace the lamp.
❶
Cleaning or Replacing the Filter
The air-lter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the
lter is dirty or clogged, your projector may overheat.
CAUTION
• Turn off the projector, turn off the main power switch and unplug the projector before replacing the lter.
• Only clean the outside of the lter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the lter cover.
NOTE:
[LV-7365]
• When the projector reaches the usage time (500 hours at the factory) specified with [Filter message] from the menu, each
time you turn on the projector, the "Please clean the filter" message will be displayed (→ page 51). When this message is dis-
played, clean the filters and reset the Filter counter (→ page 55).
• The "Please clean the filter" message will disappear when any button on the projector or the remote control is pressed.
[LV-7265/LV-7260/LV-X7]
• When the Filter counter reaches 100 hours in [Usage time] of [Information] you can select from the menu, each time you turn
on the projector, the "Please clean the filter" message will be displayed. When this message is displayed, clean the filters and
reset the Filter counter (→ page 55).
• The "Please clean the filter" message will disappear when any button on the projector or the remote control is pressed.
To clean the air-lter:
Vacuum the lter through the lter cover.
To replace the lter (sponge):
1. Removethefiltercoverbypushingdownonthecatchofthecoveruntilyoufeelitdetach.
P
U
S
H
P
U
S
H

To reset the lter usage time, from the menu, select [Reset]
→
[Filter counter].
See also page 55 for resetting the lter usage time.




Canon LV 7365 Specifications

General

Vertical scan range	50 - 120 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	300 \
Projector native resolution	XGA (1024x768)
Focus	Manual
Digital zoom	4 x
Focal length range	17.7 - 28.3 mm
Aspect ratio	4:3
Dimensions (WxDxH)	310 x 265 x 109 mm
Power requirements	100V - 240V AC, 50/60Hz
Lamp type	NSH
Lamp power	210 W
Light source type	Lamp
Dot clock scanning frequency	108 MHz
RMS rated power	5 W
Headphone outputs	1
Power consumption (standby)	9 W
Power consumption (typical)	295 W

Weight and Dimensions

Weight	3300 g