Error Message Appears on a PictBridge (Wireless LAN) Compliant
Device
The following are the possible errors that may occur when printing directly from a PictBridge (Wireless LAN)
compliant device and the countermeasures to clear them.
Note
• This section describes errors that are indicated on Canon-brand PictBridge (Wireless LAN) compliant
devices. The error messages and operations may vary depending on the device you are using. For
errors on non-Canon PictBridge (Wireless LAN) compliant devices, check the status of the Alarm lamp
and take the appropriate action to clear the error. For details, see If an Error Occurs.
• For the errors indicated on the PictBridge (Wireless LAN) compliant device and their solution, also refer
to the instruction manual of the device. For other troubles on the device, contact the manufacturer.
Error Message on
the PictBridge
(Wireless LAN)
Compliant Device
Action
"Printer in use" If the printer is printing from the computer or warming up, wait until the job ends.
When it is ready, the printer starts printing automatically.
If the printer is not printing from the computer or warming up, check the number of how many
the Alarm lamp flashes and take the appropriate action to resolve the error.
If an Error Occurs
"No paper" Load paper, and select Continue* in the display on your PictBridge (Wireless LAN) compliant
device.
* To resume printing, you can also press the RESUME/CANCEL button on the printer instead
of selecting Continue on the device.
"Paper Error" Check the number of how many the Alarm lamp flashes and take the appropriate action to
resolve the error.
If an Error Occurs
"Paper jam" Select Stop in the display on your PictBridge (Wireless LAN) compliant device to stop printing.
Remove the jammed paper, load new paper, press the RESUME/CANCEL button on the
printer, then try printing again.
"Printer cover open" Close the print head cover on the printer.
"No print head" Check the number of how many the Alarm lamp flashes and take the appropriate action to
resolve the error.
If an Error Occurs
"Waste tank full"/"Ink
absorber full"
The ink absorber is nearly full.
Check the number of how many the Alarm lamp flashes and take the appropriate action to
resolve the error.
If an Error Occurs
"No ink"/"Ink cassette
error"
Check the number of how many the Alarm lamp flashes and take the appropriate action to
resolve the error.
361
To Next Page
Loading...
Need help?
General
