Carrier 59TP6B User Manual

73
A190048
Fig. 65 -- Furnace Setup Switch Description
1. Default A/C airflow when
A/C setup switches are in
OFF position.
2 . D e f a u l t L o w --- S t a g e A / C
airflow when CF switches
are in OFF position
A190148
Fig. 66 -- Airflow Selection (based on 350 CFM/TON) for A/C (SW2-- 6, 7, 8) and *CF (SW2-- 3, 4, 5)

Carrier 59TP6B Specifications

General

Stages	Two-stage
Blower Motor	Variable-speed
Energy Star Certified	Yes
Fuel Type	Natural gas
Heat Exchanger	Stainless Steel
Heating Capacity	40, 000 - 120, 000 BTUh
Warranty	10-year parts

Summary

Installation, Start-up, Operating and Service and Maintenance Instructions

IMPORTANT

Required Notice for Massachusetts Installations

SAFETY CONSIDERATIONS

INTRODUCTION

Table 1 - Minimum Clearances to Combustible Materials for All Units

CODES AND STANDARDS

ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS PROCEDURE

LOCATION

Multipoise Orientations

Garage Installation Safety Warnings

Warnings regarding fire, injury, or death hazard when installing in a garage.

Prohibited Installation Configurations Warning

Fire hazard warning about prohibited installation configurations.

AIR FOR COMBUSTION AND VENTILATION

Indoor Combustion Air NFPA & AGA Standard and Known-Air-Infiltration Rate Methods

Standard Method

Table 3 - Minimum Free Area Required for Each Combustion Air Opening or Duct to Outdoors

CONDENSATE TRAP

CONDENSATE DRAIN CONNECTION

INSTALLATION

Return Air Connections

Platform Furnace Support

Filter Arrangement

Filter and Return Duct Sizing

Table 6 - Filter Media Pressure Drop (Clean) Versus Face Velocity- In. W.C. (Pa)

Table 7 - Air Filter Selection and Duct Sizing - In. (mm)

Table 8 - Opening Dimensions - In. (mm)

AIR DUCTS

General Requirements

Table 9 – Cooling⁴ and Heating Air Delivery - CFM (Bottom Return with Filter)

Table 9 - Cooling⁴ and Heating Air Delivery - CFM (Bottom Return with Filter) continued

GAS PIPING

ELECTRICAL CONNECTIONS

J-Box Installation

External Electrical Box on Furnace Casing

Power Cord Installation in Furnace J-Box

24-V Wiring

Table 11 - Electrical Data

NOTES FOR THERMOSTAT WIRING DIAGRAMS

VENTING

General guidelines and considerations for furnace venting systems.

WARNING

Table 12 - Approved Combustion-Air and Vent Pipe, Fitting and Cement Materials (USA Installations)

Venting Systems

Details requirements for venting systems.

Table 13 - Vent Termination Kit for Direct Vent (2-pipe) Systems

Ventilated Combustion Air

Termination Requirements for the Provinces of Alberta and Saskatchewan

Configure the Furnace

NOTES FOR VENTING OPTIONS

Optional Installation of the Vent Pipe

Installing the Vent Termination

Roof Terminations

NOTE: Maximum Equivalent Vent Length (MEVL) includes standard and concentric vent termination and does NOT include elbows.

Table 16 - Maximum Equivalent Vent Length - Ft.

Provides maximum allowable vent lengths based on furnace size and altitude.

Venting System Length Calculations

START-UP, ADJUSTMENT, AND SAFETY CHECK

General

Adjustments

FIRE HAZARD

Fire hazard warning regarding gas valve regulator adjustment.

Check Inlet Gas Pressure

Adjust Manifold Pressure

Clocking the Meter

Procedure for verifying natural gas input rate by clocking the meter.

Adjust Blower Off Delay (Heat Mode)

Adjust Cooling Airflow – High-Speed and Low-Speed Cooling

Adjusting blower airflow for cooling modes.

Check Safety Controls

SERVICE

LED CODE

COMPONENT TEST

Procedure for testing furnace components.

Table 18 - Altitude Derate Multiplier for USA

Table 19 - Blower Off Delay Setup Switch

Table 20 - Gas Rate (CU ft./hr)

Table 21 - Orifice Size and Manifold Pressure (In. W.C.) for Gas Input Rate (Continued)

SERVICE AND MAINTENANCE PROCEDURES

Care and Maintenance

Cleaning and/or Replacing Air Filter

WARNING

CO poisoning and fire hazard warning for filter operation.

Fig. 68 - Burner Assembly

Cleaning Burners and Flame Sensor

Procedure for cleaning burners and flame sensor.

Servicing Hot Surface Igniter

Flushing Collector Box and Drainage System

Procedure for flushing the collector box and drainage system.

Cleaning Heat Exchangers

Primary Heat Exchangers

WINTERIZATION

CAUTION

Caution regarding unit and property damage from freezing.

SEQUENCE OF OPERATION

1. Two-Stage Heating (Adaptive Mode) with Single-Stage Thermostat

Describes two-stage heating operation with a single-stage thermostat.

3. Cooling mode

a. Single-Speed Cooling-

4. Dehumidification Mode

5. Continuous Blower Mode

Explains the continuous blower mode and its selections.

Fig. 72 - Troubleshooting Guide

Troubleshooting Guide (Continued)

PARTS REPLACEMENT INFORMATION GUIDE

WARNING

Warning about using only factory-authorized replacement parts.