Cisco 7925G - Unified Wireless IP Phone VoIP User Manual

CHAPTER
3-1
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
3
Setting Up the Cisco Unified Wireless IP Phone
7925G
This chapter includes the following topics, which help you install and configure the Cisco Unified
Wireless IP
Phone 7925G on an IP telephony network:
• Before You Begin, page 3-1
• Installing the Cisco Unified Wireless IP Phone 7925G, page 3-7
• Understanding the Phone Startup Process, page 3-17
Before You Begin
Before installing a Cisco Unified Wireless IP Phone 7925G, review the requirements in these sections:
• Network Requirements, page 3-1
• Methods for Adding Phones to Cisco Unified Communications Manager, page 3-2
• Device Support, page 3-5
• Safety Information, page 3-5
Network Requirements
For the Cisco Unified Wireless IP Phone 7925G to successfully operate as a Cisco Unified IP Phone
endpoint, your network must support these requirements:
Voice over Wireless LAN
• Cisco Aironet Access Points (APs) configured to support Voice over WLAN (VoWLAN)
• Controllers and switches configured to support VoWLAN
• Security implemented for authenticating wireless voice devices and users
Note You must verify that your wireless network is configured properly for voice service. For more
information, see the “Performing a Site Survey Verification” section on page 2-23.

Cisco 7925G - Unified Wireless IP Phone VoIP Specifications

General

Brand	Cisco
Model	7925G - Unified Wireless IP Phone VoIP
Category	IP Phone
Language	English