Cisco 7925G - Unified Wireless IP Phone VoIP User Manual

3-12
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7925G
Installing the Cisco Unified Wireless IP Phone 7925G
Using the USB Cable and PC to Charge the Battery
Charge the phone battery by using a USB cable connected to your PC. Follow the steps in Figure 3-5.
Figure 3-5 Charging the Phone Battery Using the USB Cable and PC
Note While the battery is charging, the indicator light is red. When the battery is fully charged, the indicator
light turns green. Charging times are longer when you use this method and are described in Table 3-4.
Related Topics
• Powering On the Cisco Unified Wireless IP Phone 7925G, page 3-15
• Installing or Removing the Phone Battery, page 3-8
1 Insert the phone connector on the USB cable into the phone.
2 Insert the USB A-type connector into the USB port on your PC.
3 Monitor the indicator light after the phone briefly displays “USB Connected” on the status
line.
You may see the “Found New Hardware Wizard” To stop the wizard from opening when
connecting to USB port, perform the following steps:
1. Click Next to use the wizard dialog box.
2. In the Update New Software dialog, click No, not this time, and click Next.
3. Click Install the Software automatically (Recommended) and click Next.
4. After a few moments, the Cannot Install This Hardware dialog displays. Click Don't
prompt me again to install this software.
5. Click Finish to close the dialog box.
187639
1
2
3

Cisco 7925G - Unified Wireless IP Phone VoIP Specifications

General

Brand	Cisco
Model	7925G - Unified Wireless IP Phone VoIP
Category	IP Phone
Language	English