3-6
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7925G
Before You Begin
Warning
The battery charger requires short-circuit (overcurrent) protection to be provided as part of the
building installation. Install only in accordance with national and local wiring regulations.
Statement
1045
Warning
The power supply must be placed indoors.
Statement 331
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
Telephone receivers produce a magnetic field that can attract small magnetic objects such as pins
and staples. To avoid the possibility of injury, do not place the handset where such objects may be
picked up.
Battery Safety Notices
The following battery safety notices apply to the batteries that are approved by the Cisco Unified
Wireless IP
Phone 7925G manufacturer.
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer’s instructions.
Statement 1015
Warning
Do not dispose of the battery pack in fire or water. The battery may explode if placed in a fire.
Caution The battery pack is intended for use only with this device.
Caution Do not disassemble, crush, puncture, or incinerate the battery pack.
Caution To avoid risk of fire, burns, or damage to your battery pack, do not allow a metal object to touch the
battery contacts.
Caution Handle a damaged or leaking battery with extreme care. If you come in contact with the electrolyte, wash
the exposed area with soap and water. If the electrolyte has come in contact the eye, flush the eye with
water for 15 minutes and seek medical attention.
To Next Page
Loading...
Need help?
General