Adjust Phone Ringer Volume Level
Check with your system administrator to see if a minimum ringer volume setting was configured.
Procedure
Press while the handset is in the cradle and the headset and speakerphone buttons are off. The new
ringer volume is saved automatically.
Change Ring Pattern (Flash-Only, Ring Once, Beep-Only)
Before you can access this setting, your system administrator might need to enable it for you.
Procedure
Step 1
Log in to your User Options web pages.
Step 2
Access your call ring pattern settings.
Change Audible Voice-Message Indicator
Procedure
Step 1
Log in to your User Options web pages.
Step 2
Access your message indicator settings.
Change How Voice Message Light on Handset Works
Procedure
Step 1
Log in to your User Options web pages.
Step 2
Choose Change the Message Waiting Lamp policy.
Step 3
Access your message indicator settings. Typically, the default system policy is to indicate a new voice message
by displaying a steady light on the handset light strip.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
66
Phone Customization
Adjust Phone Ringer Volume Level
To Next Page
Loading...
Need help?
General
