Cisco IE 4010 User Manual

MeaningPort LED ColorPort Mode LED
One or more redundancy protocols
are configured and active (for
example, HSR, DLR, PRP, etc.)
GreenREDUN
One or more redundancy protocols
are indicating a redundancy fault.
Blinking amber
The port LEDs are showing ports
that are participating in a
redundancy protocol and the
redundancy fault status of that port.
Fast blinking green
OffSYNCE
PoE/PoE+ is off.
OffPoE/PoE+
PoE/PoE+ is on and all ports
function correctly. The port LED
is green when the switch port is
providing power.
Green
PoE/PoE+ is on but one of the low
priority ports power is disconnected
or failed.
Alternating green and amber
PoE/PoE+ is on but one of the high
priority ports power is disconnected
or failed.
PoE+ faults occur when
noncompliant cabling or powered
devices are connected to a PoE+
port. Use only standard-compliant
cabling to connect Cisco
prestandard IP Phones and wireless
access points or IEEE
802.3af/at-compliant devices to
PoE+ ports. You must remove from
the network any cable or device
that causes a PoE+ fault.
Blinking amber
PoE/PoE+ is on with failures.
PoE+ is enabled by default
Amber
Display Mode Button
The Display Mode Button allows you to choose the mode you want displayed by the port LEDs. The LEDs
with green text to the left of the Button indicate the chosen display mode. Each time you press the switch, the
mode indicator moves from SPEED, DUPLX, REDUN, SYNCE, and PoE respectively.
Cisco IE 4010 Switch Hardware Installation Guide
9
Product Overview
Display Mode Button

Cisco IE 4010 Specifications

General

Brand	Cisco
Model	IE 4010
Category	Switch
Language	English