Cisco IE 4010 User Manual

Use twisted-pair supply wires suitable for 86°F (30°C) above surrounding ambient temperature outside the
enclosure. Statement 1067
Warning
When used in a Class I, Division 2, hazardous location, this equipment must be mounted in a suitable enclosure
with a proper wiring method that complies with the governing electrical codes. Statement 1069
Warning
Explosion Hazard—The area must be known to be nonhazardous before installing, servicing, or replacing the
unit. Statement 1082
Warning
This equipment has been tested by UL for the explosion, fire, shock and casualty hazards required by the
applicable hazardous locations standards. UL certification does not cover the performance or reliability of
any GPS hardware, GPS operating software, or other GPS-related aspects of equipment covered under this
category. Accordingly, UL makes no representations, warranties or certifications regarding the performance
or reliability of any GPS-related functions of equipment covered under this category.
Note
North American Hazardous Location Approval
The following information applies when operating this equipment in hazardous locations:
Products marked "Class I, Div 2, GP A, B, C, D" are suitable for use in Class I
Division 2 Groups A, B, C, D, Hazardous Locations and nonhazardous locations
only. Each product is supplied with markings on the rating nameplate indicating
the hazardous location temperature code. When combining products within a
system, the most adverse temperature code (lowest "T" number) may be used to
help determine the overall temperature code of the system. Combinations of
equipment in your system are subject to investigation by the local Authority Having
Jurisdiction at the time of installation.
English:
Informations sur l'utilisation de cet équipement en environnements dangereux:
Les produits marqués "Class I, Div 2, GP A, B, C, D" ne conviennent qu'à une
utilisation en environnements de Classe I Division 2 Groupes A, B, C, D dangereux
et non dangereux. Chaque produit est livré avec des marquages sur sa plaque
d'identification qui indiquent le code de température pour les environnements
dangereux. Lorsque plusieurs produits sont combinés dans un système, le code de
température le plus défavorable (code de température le plus faible) peut être utilisé
pour déterminer le code de température global du système. Les combinaisons
d'équipements dans le système sont sujettes à inspection par les autorités locales
qualifiées au moment de l'installation.
Français:
Cisco IE 4010 Switch Hardware Installation Guide
57
Hazardous Location Installation Information
North American Hazardous Location Approval

Cisco IE 4010 Specifications

General

Brand	Cisco
Model	IE 4010
Category	Switch
Language	English