Cisco IE 4010 User Manual

Alarm Port
The alarm port uses an RJ-45 connector. See 100/1000 SFP Ports, on page 5 for more information. For
information on alarm ratings, see Alarm Ratings, on page 79.
Figure 39: Alarm Port Details
Cables and Adapters
This section contains the following:
SFP Module Cables
Each port must match the wave-length specifications on each end of the cable, and for reliable communications,
the cable must not exceed the allowable length.
For more information about SFP/SFP+ modules and cables, see Transceiver Modules.
Console Port Adapter Pinouts
The console port uses an 8-pin RJ-45 connector. If you did not order a console cable, you need to provide an
RJ-45-to-DB-9 adapter cable to connect the switch console port to a PC console port. You need to provide
an RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. You
can order an adapter (part number ACS-DSBUASYN=).
The following tables list the pinouts for the console port, the RJ-45-to-DB-9 adapter cable, and the console
device.
Cisco IE 4010 Switch Hardware Installation Guide
63
Cable and Connectors
Alarm Port

Cisco IE 4010 Specifications

General

Brand	Cisco
Model	IE 4010
Category	Switch
Language	English