CKD RAPIFLOW FSM3 Series User Manual

FSM3 Series
Product-specic cautions
1
Separated display FSM2-D Series
Mounting, installation and adjustment
CAUTION
Cut the half-strip section at the end of the e-con connector wiring before use. Insert the wire through to
the back of the connector, and securely crimp with pliers, etc.
The wire sheath does not need to be removed.
Check that the pin No. and wire color are correct before crimping.
Incorrect wiring can lead to sensor or separated indicator damage, faults or malfunction.
When attaching or removing the cable, hold the connector instead of the cable.
Holding the cable could result in a contact fault, broken wire or short-circuit, etc., could damage the
sensor or separated indicator, or cause malfunctions.
Do not apply a load of 15 N and over onto the cable.
Brown
Black
White
Blue
Brown
Black
White
Blue
Align these numbers
to the colors
Crimp with pliers,
etc.
Avoid getting the color
order wrong
1-brown, 2-black,
3-white, 4-blue
Insert the wire
through to the
back
4 conductor cable
(FSM2-C4
)
Design/selection
CAUTION
The corresponding sensor is the voltage output (1 to 5 V) type. If the current output type or other voltage
output type is connected, it doesn't operate properly. When using FSM3, use the bar display type voltage
output.
* The e-con connector is attached with the separated display.
e-con Connector
Refer to page 30 for
the model No.
4
3
2
1
50
LCD display Bar display
IO
-
Link
Internal
structure
Separate
display
Technical
data
Operating
method
Optional
products
Safety
precautions
Related
products

CKD RAPIFLOW FSM3 Series Specifications

General

Brand	CKD
Model	RAPIFLOW FSM3 Series
Category	Accessories
Language	English